: Minimum 10K sampling points per acquired waveform.
Before first use, you should connect your probe to the calibration terminal (usually a 1 kHz square wave) and adjust the compensation trimmer until the wave is flat. Measurement Modes:
Use the [Measure] menu to display automatic measurements like frequency, peak-to-peak voltage ( Vppcap V sub p p end-sub ), and average voltage.
: A dedicated 6-bit counter capable of measuring frequencies from 2 Hz to 20 MHz. Interface & Portability Hanmatek DOS1102 Oscilloscope Review
: Minimum 10K sampling points per acquired waveform.
Before first use, you should connect your probe to the calibration terminal (usually a 1 kHz square wave) and adjust the compensation trimmer until the wave is flat. Measurement Modes:
Use the [Measure] menu to display automatic measurements like frequency, peak-to-peak voltage ( Vppcap V sub p p end-sub ), and average voltage.
: A dedicated 6-bit counter capable of measuring frequencies from 2 Hz to 20 MHz. Interface & Portability Hanmatek DOS1102 Oscilloscope Review
Copyright © 2013 – 2025 Retouching Zone. All rights reserved.
