Digi Sm500 Scale User Manual Exclusive Page

| Error | Solution | |-------|-----------| | PAPER OUT | Reload label roll, clean sensor | | HEAD OPEN | Close printer cover fully | | NO FORMAT | Missing label format – call service |

: To communicate with a PC, the scale and computer must be on the same submask (e.g., if the PC is 192.168.168.XXX , the scale's IP must match the first three sets). Memory Capacity digi sm500 scale user manual exclusive

If it ends with “-R” (Refurbished), your auto-shutdown is permanently set to 2 minutes; you cannot override it. | Error | Solution | |-------|-----------| | PAPER

If the scale skips labels, it usually means the "Gap Sensor" is dirty. Clean the clear plastic sensors located in the label roll compartment. 4. Networking and Data Management The SM-500 typically communicates via Ethernet (TCP/IP). Clean the clear plastic sensors located in the

Introduction

If you see “CAL E” or “C Err”, your load cell may be overloaded or the weight is wrong. Repeat with a certified calibration weight only.

The scale beeped twice, impatient.