Kt 70 Installation Manual [ TESTED ✔ ]

| Code | Cause | Solution | |------|-------|----------| | | Sensor open or reversed | Check continuity; reverse TC wires (no polarity on RTD) | | HHH | Input > range | Sensor type mismatch or short circuit | | LLL | Input < range | Sensor disconnected or below zero | | E.OP1 | Output 1 short-circuit | Check SSR or heater coil resistance |

The manual covers the physical and electrical integration of the KT 70 into an aircraft's avionics stack. Target Device: BendixKing KT 70 Mode S Transponder.

You will need to solder or crimp a 5-pin Julet female pigtail to the controller’s wiring. Use this mapping: