Find Schools, Start Your Search
Thank you! Your submission has been received!
Oops! Something went wrong while submitting the form.
🔒 Your information is secure and only used to match you with relevant programs.
Thread the TS1162 into the port by hand until it seats. The exclusive manual requires that you feel resistance exactly at 1.5 turns after initial contact. If you feel resistance earlier, cross-threading has occurred.
: Includes a dedicated input for an egress button or RTE control. ts1162 installation manual exclusive
A: Yes, but with an exclusive modification . You must rotate the breather port to the 12 o’clock position and add an oil wicking ring (not supplied). Contact the manufacturer for the vertical mounting kit—do not attempt without it, or you’ll starve the upper bearing. Thread the TS1162 into the port by hand until it seats
Loosen the 12 o'clock bolt just enough to slide out the 0.05mm shim. Retighten that bolt to the original thermal pre-load value. You have now achieved true zero-gap contact. : Includes a dedicated input for an egress
: Select a flat, solid, vertical surface. Mounting on uneven surfaces can cause the base to flex, potentially compromising the IP67 seal.
Using a calibrated torque wrench, tighten to . Pause for 10 seconds. Then tighten to 18 Nm in one smooth motion. The ts1162 installation manual exclusive includes a note: "Never use an impact driver. The piezoelectric crystal inside the TS1162 will fracture under impulse loading."