Mcgs Hmi Touch Calibration [repack] Jun 2026

| Symptom | Likely Cause | Solution | |---------|--------------|----------| | Calibration loop (keeps asking for calibration) | Incorrect press order or touching the edge of the target | Power cycle, re-enter calibration, press firmly in the exact center | | One axis is inverted (left/right swapped) | Corrupted touch controller data | Perform hardware calibration (Method 1) | | No response to touch at all | Broken digitizer or loose ribbon cable | Hardware repair required; calibration will not help |

The good news? Fixing this takes less than 30 seconds. Let’s walk through why calibration drifts, how to perform it, and what to do if the standard method fails. mcgs hmi touch calibration

If misalignment persists, repeat calibration, ensuring you press the exact center of each target. | Symptom | Likely Cause | Solution |